Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2010, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 30 Nov 2010 22:31:36 -0500
Reply-To:     John Meeks <vanagon@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Meeks <vanagon@GMAIL.COM>
Subject:      Re: Power Steering Fluid and lines Questions
Comments: To: Jarrett Anthony Kupcinski <kupcinski@gmail.com>
In-Reply-To:  <83028AF2-8122-4E9A-9FD8-4A23DB7420C8@gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

Jarrett,

I installed the hose kit a couple of years ago. Got mine from Frank Condelli(.com). It's a fairly straight forward operation. Tape or otherwise wrap the hose ends to keep all the nasty crap thats likely sitting on top of you fuel tank. Fasten the hose pair often along the way with the BIG tie wraps.

If you can't make the repair right away and don't want to keep leaking fluid, you can remove the PS pump belt and drive manual steering till you replace the hose. Bleed the system by rotating the wheel from stop to stop a few times with engine running.

John Meeks '91 Vanagon MV Northern Michigan

Vanagon Rescue Squad www.vanagonauts.com

On Tue, Nov 30, 2010 at 9:01 PM, Jarrett Anthony Kupcinski < kupcinski@gmail.com> wrote:

> I've discovered leaky-ness in my power steering lines and a low fluid level > today. I'll need to do a complete investigation to figure out where the > problem(s) are, but in the meantime I want to top off the fluid reservoir. > > I have purchased some Dexron III (H) spec ATF, and I want to make sure this > is acceptable before I pour it in. Can anyone confirm that this is the > correct type of fluid for an 89 Westy? > > Also, I know that the lines are going out, and I'm probably looking at > having to do a replacement of the metal lines (and perhaps others). I saw > that Ken over at Vanagain has a replacement hydraulic line set to replace > the metal lines. Does anyone have any experience with line replacement with > this (or other) hydraulic line products? I'd appreciate any advice that can > be given, as I've never worked on the PS system in the van before. Sir > Bentley offers only the vaguest of guidance, unfortunately. > > Thanks, > > Jarrett > 89 Westy, Oly


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.