Date:         Wed, 1 Dec 2010 12:16:13 -0700
Reply-To:     Karl Wolz <wolzphoto@Q.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Karl Wolz <wolzphoto@Q.COM>
Subject:      Re: What fasteners to hold windshield washer tank to frame?
Comments: To: Dennis Haynes <d23haynes57@HOTMAIL.COM>
In-Reply-To:  <BAY152-ds1006D745EF765446249ADCA0260@phx.gbl>
Content-Type: text/plain; charset="us-ascii"

... and if the tabs are broken off, plumbers tape (steel tape with holes
every inch or so) works a treat to retain your bottle!

Karl Wolz

|
|6mm is the original size. The washers were oversized. USS 1/4' will work
|fine. The speed clips will take most any screw that is close.
|
|Dennis
|

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.