Date:         Wed, 8 Dec 2010 10:48:12 -0800
Reply-To:     neil n <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil n <musomuso@GMAIL.COM>
Subject:      Re: Transmission replacement
Comments: To: zzyzx <zzyzx9@gmail.com>
In-Reply-To:  <4CFFAFA8.2090309@gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

If one swapped in the entire older style linkage, could they add the
"missing" center linkage bushing (the one normally over fuel tank) at hole
where front rod exits?

*pic of newer style bushing installed on my '81  (I did the reverse
installing an '85 transmission + linkage)*
*
*
*http://tinyurl.com/325lcdj*
*
*
*I think ID of that part is too large for the older style shift rod but
maybe something else there?*
*
*
*Not sure if moving that center bushing further aft would allow the "U"
joint on front portion of rod to do its' thing properly though.*
*
*
*IIRC the old style front rod exits this same hole. *
*
*
*Neil.
*
On Wed, Dec 8, 2010 at 8:17 AM, zzyzx <zzyzx9@gmail.com> wrote:

> Will a stock 1980 air cooled transmission provide service in 1983.5
> watercooled without mods to mounting points and linkage?
> Both are 4 spd.
>
> I have a 1983.5 with a bad trans and hope my 1980 parts bus trans can be
> used in the 1983.5
>
> All comments appreciated.
>



--
Neil Nicholson '81 VanaJetta 2.0 "Jaco"

http://tubaneil.googlepages.com/

http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines