Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2010, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 18 Dec 2010 22:39:47 -0500
Reply-To:     John Lauterbach <jhlauterbach@BELLSOUTH.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Lauterbach <jhlauterbach@BELLSOUTH.NET>
Subject:      Routing of rubber fuel line from engine back to fuel pump
Content-Type: text/plain; charset="UTF-8"

I have now replaced both the original hard plastic fuel and the plastic firewall connector. I still have to "tie" the fuel line to the body or other pipes. Is there a preferred routing for the rubber fuel line?

The original went from the firewall connector up and through a ring at the top of the right rear wheel well and then down to another ring at the bottom front of that wheel well before going through a cross member and then forwards to the pump.

Van is '84 with automatic transmission.

John


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.