Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2010, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 22 Dec 2010 16:49:45 -0800
Reply-To:     Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject:      Re: [Syncro] Syncro Transmission Removal Advice?
Comments: To: craig cowan <phishman068@GMAIL.COM>
Content-Type: text/plain; format=flowed; charset="Windows-1252";
              reply-type=original

I've done this many times. if the task is to swap out the starter .. my suggestion is don't even consider it until lowering the rear of the engine a little. It's only a matter of a few bolts, the front trans mount and shift linkage are designed to pivot a little... so it's super easy to lower the rear of the engine a little ( undo bolts at outer ends of rear engine mounting bar ) . Sometimes I hang it by longer bolts on the end . This gives great access to the starter and anything to do with the clutch slave cylinder.

I sell, btw, clutch slave cylinder brackets with 'that bolt' ( the one with the nut on the bottom you can barely get a short 13mm open end wrench on ) ...........with that bolt and nut arrangement turned into a stud . That way it's hyper easy any time to unbolt the two slave cyl mounting bolts ( and forward bracket ) . Only need to do it to your van once, then from then clutch slave is a breeze to unbolt.

in any case ......don't try accessing the starter or slave without lowering the rear of the engine a little.

what fun these vans are. Scott www.turbovans.com ----- Original Message ----- From: "craig cowan" <phishman068@GMAIL.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Tuesday, December 21, 2010 8:13 PM Subject: Re: [Syncro] Syncro Transmission Removal Advice?

Nope, the bostig's in the other van.

-Craig

On Tue, Dec 21, 2010 at 11:07 PM, Kim Brennan <kimbrennan@mac.com> wrote:

> > > Ah I see you have a bostig engine. That should make some of >my< pain > points (with a boxer engine) irrelevant. I am also not positive that the > mounts for the bostig engine are as one sided as they are on boxer > engines. > > Sent from somewhere > > > On Dec 21, 2010, at 11:03 PM, Kim Brennan > <kimbrennan@mac.com<kimbrennan%40mac.com>> > wrote: > > > From experience Have a helper around. While one person can do the job > it's a pain to coordinate. You need two jacks in my opinion. One for > engine > one for motor. > > > > You really can't leave starter for last as it is one of the bolts > > holding > the trans to motor. Plus you'll have loosen the nut pull trans a little > then > repeat until the top starter nut is off. Hardest part of all is the clutch > slave. Don't disconnect the hydraulic line. But you'll be cursing the > access > to the nut in the bracket until you get the slave loosened from the > bracket. > > > > For cleanly working under van, pulling the half shafts completely is > recommended. It is not that much more effort, and the extra room will be > welcome. > > > > No you don't need to disconnect any coolant lines. You do have to > disconnect the breather line on the top of trans. That unbolts. > > > > > > Sent from somewhere > > > > On Dec 21, 2010, at 10:23 PM, craig cowan > > <phishman068@gmail.com<phishman068%40gmail.com>> > wrote: > > > >> So I'm pulling the transmission to see if I can't find the problem with > the > >> clutch and while I love to just get in there and get my hands dirty, I > like > >> to ask sages for advice first. > >> So, any advice? > >> > >> I've got the bars off, the driveshaft off, the shifter disconnected, > >> the > >> ground strap off, and the CV bolt heads cleaned. First thing on the > >> list > is > >> removal of the CV's. I presume that really just leaves (aside from the > >> engine to transmission bolts), the Clutch Slave, the coolant pipes, and > the > >> starter. > >> > >> Clutch Slave- Leave in place and disconnect the line? Or remove. If so, > >> tricks? > >> > >> Coolant pipe- I don't need to remove any hoses or drain any coolant > right? > >> Just unbolt it. > >> > >> Starter- Last. Do it with the transmission lowered a few inches. > >> > >> It is worth noting that it is quite cold outside, and there is a good > amount > >> of snow surrounding the bus. I also have the grave inconvenience of > having > >> to have one hand far too overly well bundled which burdens dexterity. > This > >> is being performed on a deep bed of loose gravel, with floor jack with > >> wheels that insist upon simply sinking into the gravel. > >> But I like to say, when life gives you lemons..... find some rum. > >> I've got rum. Soo, the situation can't be that bad. > >> > >> Advice? > >> > >> -Craig > >> '87 SUNROOF Syncro > >> '85 GL turned WESTY > >> BOSTIG in the back > >> > >> > >> [Non-text portions of this message have been removed] > >> > >> > >> > >> ------------------------------------ > >> > >> Please note that the default "Reply" function will route your reply to > the entire group. If you have a private message for a member you'll need > to > specifically address your message to them. > >> If you would like to modify your subscription settings (including > unsubscribing), visit: > >> http://groups.yahoo.com/group/Syncro > >> Rude or offensive language is not allowed on the Syncro list. Please > >> try > your best to resolve differences privately and keep them off the list. > >> > >> > >> > >> > >> > >> > >> > >> > >> > >> > >> > >> > >> > >> Yahoo! Groups Links > >> > >> > >> > > > > > > ------------------------------------ > > > > Please note that the default "Reply" function will route your reply to > the entire group. If you have a private message for a member you'll need > to > specifically address your message to them. > > If you would like to modify your subscription settings (including > unsubscribing), visit: > > http://groups.yahoo.com/group/Syncro > > Rude or offensive language is not allowed on the Syncro list. Please try > your best to resolve differences privately and keep them off the list. > > > > > > > > > > > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > __._,_.___ > Reply to > sender<kimbrennan@mac.com?subject=Re%3A%20%5BSyncro%5D%20Syncro%20Transmission%20Removal%20Advice%3F>| > Reply > to > group<Syncro@yahoogroups.com?subject=Re%3A%20%5BSyncro%5D%20Syncro%20Transmission%20Removal%20Advice%3F>| > Reply > via web > post<http://groups.yahoo.com/group/Syncro/post;_ylc=X3oDMTJvcnNtYTkwBF9TAzk3MzU5NzE0BGdycElkAzgzNzQ5BGdycHNwSWQDMTcwOTkyNjI0MARtc2dJZAM0NzQ4NgRzZWMDZnRyBHNsawNycGx5BHN0aW1lAzEyOTI5OTA4OTE-?act=reply&messageNum=47486>| > Start > a New > Topic<http://groups.yahoo.com/group/Syncro/post;_ylc=X3oDMTJjNnUwM2tkBF9TAzk3MzU5NzE0BGdycElkAzgzNzQ5BGdycHNwSWQDMTcwOTkyNjI0MARzZWMDZnRyBHNsawNudHBjBHN0aW1lAzEyOTI5OTA4OTE-> > Messages in this > topic<http://groups.yahoo.com/group/Syncro/message/47484;_ylc=X3oDMTM0dGVmYzczBF9TAzk3MzU5NzE0BGdycElkAzgzNzQ5BGdycHNwSWQDMTcwOTkyNjI0MARtc2dJZAM0NzQ4NgRzZWMDZnRyBHNsawN2dHBjBHN0aW1lAzEyOTI5OTA4OTEEdHBjSWQDNDc0ODQ->( > 3) > Recent Activity: > > - New > Members<http://groups.yahoo.com/group/Syncro/members;_ylc=X3oDMTJkZDhuajljBF9TAzk3MzU5NzE0BGdycElkAzgzNzQ5BGdycHNwSWQDMTcwOTkyNjI0MARzZWMDdnRsBHNsawN2bWJycwRzdGltZQMxMjkyOTkwODkx?o=6> > 3 > > Visit Your > Group<http://groups.yahoo.com/group/Syncro;_ylc=X3oDMTJjOWkxMm8yBF9TAzk3MzU5NzE0BGdycElkAzgzNzQ5BGdycHNwSWQDMTcwOTkyNjI0MARzZWMDdnRsBHNsawN2Z2hwBHN0aW1lAzEyOTI5OTA4OTE-> > Please note that the default "Reply" function will route your reply to > the entire group. If you have a private message for a member you'll need > to > specifically address your message to them. > If you would like to modify your subscription settings (including > unsubscribing), visit: > http://groups.yahoo.com/group/Syncro > Rude or offensive language is not allowed on the Syncro list. Please try > your best to resolve differences privately and keep them off the list. > > > > > > > > > > > > > > [image: Yahoo! > Groups]<http://groups.yahoo.com/;_ylc=X3oDMTJib2ZoNWs5BF9TAzk3MzU5NzE0BGdycElkAzgzNzQ5BGdycHNwSWQDMTcwOTkyNjI0MARzZWMDZnRyBHNsawNnZnAEc3RpbWUDMTI5Mjk5MDg5MQ--> > Switch to: > Text-Only<Syncro-traditional@yahoogroups.com?subject=Change+Delivery+Format:+Traditional>, > Daily > Digest<Syncro-digest@yahoogroups.com?subject=Email+Delivery:+Digest>• > Unsubscribe <Syncro-unsubscribe@yahoogroups.com?subject=Unsubscribe> • > Terms > of Use <http://docs.yahoo.com/info/terms/> > . > > __,_._,___ >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.