Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2011, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 4 Jan 2011 14:05:20 -0800
Reply-To:     Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject:      Re: Koni Shock adjustment?
Comments: To: Greg Potts <greg@POTTSFAMILY.CA>
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
              reply-type=response

the way koni's are traditionally adjust is to compress the shock fully by hand.. then rotate the top part relative to the bottom part.

been forever ..it's something like 8 clicks from soft to full firm , stick vaguely in my mind.

it would be hard to do the adjsutment with the shock inside the spring .. it's basically unbolt the top, remove the big bolt on the bottom , withdraw the shock out the bottom, do the adjustment change ..reinstall. As little as 20 minutes per side..

even if the shocks are very firm, there shouldn't be any noise in the susension ... if there is, something is worn or loose somewhere. .

Scott www.turbovans.com

----- Original Message ----- From: "Greg Potts" <greg@POTTSFAMILY.CA> To: <vanagon@GERRY.VANAGON.COM> Sent: Tuesday, January 04, 2011 9:48 AM Subject: Koni Shock adjustment?

> Hi Volks, > > Back before the holidays I bought a pair of Koni adjustable front shocks > from BusDepot and had them installed by a local alignment specialist. > The shocks weren't actually my top priority, but I suspected they needed > doing as there was some cupping in the tire tread pattern. Then I > noticed the inside tread was wearing down, and figured that something > bad was happening there. I had the alignment shop check it out; they > ended up replacing a ball joint and a tie rod end. I figured if I was > going to replace the front tires, I had better replace the shocks first, > so I ordered them from BD and asked the alignment shop to install them > while they were doing their thing. > > When I left them the Koni's I included a note asking set up for a > slightly firm ride. When i got it back the ride was a lot harsher than I > expected. Not quite a boneshaker, but it's loud, and when the tires are > cold they don't absorb much of the impact, either. > > Is it a big deal to adjust these? The shop that did the work would > probably be open to making the adjustment for me but getting the vanagon > to them during business hours and arranging for something else to drive > while they had it would be a problem right now. If it's not a big job > then I wouldn't mind doing it once we get a break in the weather. > > Happy Trails, > > Greg Potts > Toronto, Ontario Canada > 197x Westfakia "Bob the Tomato" > 1987 Wolfsburg Weekender Hardtop (ND Graphics graphics wrap) > 1988 Wolfsburg Weekender Hardtop (Colleen's ride) > www.pottsfamily.ca > > BUSES OF THE CORN - AUGUST 12-14th, 2011 > www.busesofthecorn.ca


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.