Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2011, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 5 Jan 2011 13:57:33 -0700
Reply-To:     Tom Buese <tombuese@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Tom Buese <tombuese@COMCAST.NET>
Subject:      Re: Steering Question
Comments: To: Jim Arnott <jrasite@EONI.COM>
In-Reply-To:  <4431C3E434F947F4B32062838F51CE17@jimsystem>
Content-Type: text/plain; charset=us-ascii

I just had a VW bus/vanagon knowledgeable private shop do my westy alignment & it cost $60-well worth it IMHO w/ $$$ Hakka tires

YMMV,

Mr. BZ-Russ's Alignment in SLC

On Jan 5, 2011, at 12:39 PM, Jim Arnott wrote:

> After replacing those components you had it aligned, right? If not, you > should. IMHO it's worth it to be insistent that they align to to spec, not > "close enough." I'd go find a sole proprietor shop rather than a chain. > Talk up front about what you need/want. Pay the man's hourly rate rather > than the "$39.95 alignment special" price. Otherwise they'll tend to ignore > things like caster. (When you adjust the caster, it changes EVERYTHING else. > Caster adjustments are'fiddley'.) > > Jim > > > -------------------------------------------------- > From: "Jim Johnston" <inmytree1@GMAIL.COM> > Sent: Wednesday, January 05, 2011 9:33 AM > To: <vanagon@GERRY.VANAGON.COM> > Subject: [VANAGON] Steering Question > >> Hello all, >> >> I have a 1991 GL, Manual with a Subie 2.2. In August 2010, I upgraded to >> 16 >> inch Gowesty Steel Rims. A few weeks ago I replaced worn upper ball >> joints >> and put on new shocks all around. The lower ball joints looked ok, the >> tie >> rod ends looked a bit worn. >> >> Last week I noticed, when driving straight, my steering wheel is off >> slightly, whereas it I have to keep it slightly turned to the left (maybe >> an >> inch, if that) to keep things straight. My first thought is alignment, >> but >> before I take it to a shop and drop some cash, I'd consult the list for >> other possible issues. >> >> Worn tie rods ends? Worn upper bushings? Steering Rack? All of the >> above...? >> >> Any input would be appreciated. >> >> Jim >> Wilmington, NC


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.