Date:         Wed, 19 Jan 2011 19:51:42 -0800
Reply-To:     Alistair Bell <albell@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alistair Bell <albell@SHAW.CA>
Subject:      Re: Front Wheel Bearing Adjustment (searched)
Comments: To: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
In-Reply-To:  <054401cbb852$9606fae0$6701a8c0@PROSPERITY>
Content-Type: text/plain; charset=US-ASCII; format=flowed; delsp=yes

can you explain that more? I'm stuck at the "cotter pin is just
slightly off center".

alistair


On 19-Jan-11, at 7:31 PM, Scott Daniel - Turbovans wrote:

>
> the cotter pin is just slightly off center ..
> that gives 'half' of each division of the castle nut possible...or
> double
> the number of slots in the castle nut -  I believe, plenty enough
> choices
> for fine adjustment.

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.