Date: Sun, 16 Jan 2011 08:18:24 -0800
Reply-To: Stephen Grisanti <bike2vcu@YAHOO.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Stephen Grisanti <bike2vcu@YAHOO.COM>
Subject: Re: Sound deadening and door speakers
In-Reply-To: <F4B13513AC634A6AB68183DDA4DC495B@Mikelaptop1>
Content-Type: text/plain; charset=iso-8859-1
I have some of the gravel-topped stuff left over from a roof job, but I used the foil-backed roof patch that seems very similar to the B-Quiet sound deadener. I did the right door in the last of the real stuff I had already used on the back of the van, but tried the Peel and Patch on the driver's door and it went on and performs no differently from the B-Q. It's cheaper per square foot and easier to obtain. There may be some offgassing chemical reason not to use it but that's a for a different thread.
Can't help you with the speakers.
Stephen
--- On Sat, 1/15/11, Mike <mbucchino@CHARTER.NET> wrote:
From: Mike <mbucchino@CHARTER.NET>
Subject: Re: Sound deadening and door speakers
To: vanagon@GERRY.VANAGON.COM
Date: Saturday, January 15, 2011, 11:09 PM
Sound deadening butyl is plain, but ice and water shield has gravel (like
asphalt shingles do) on top.
I have a bunch here from my home addition, but didn't try it due to this
fact. It's heavy.
Mike B.
-----Original Message-----
From: Jonathan Edwards
Sent: Saturday, January 15, 2011 10:19 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Sound deadening and door speakers
Hey folks - I'm in the process of replacing my damaged 2 front interior door
panels and got a couple questions.
First off, while I've got the panels off and door frame exposed, I'd like to
do some sound deadening. I've heard of people using "Ice and Water Shield"
which is a urethane/rubber underlayment used in home roofing. It can be
purchased at Home Depot, etc, and is considerably cheaper than products
marketed as 'sound deadening' specific, and it appears to be pretty similar
stuff. Have any of you used it for this purpose, or have any thoughts? And
would I apply a stick-on sound deadening material like this between the door
panel and the door, or is it possible/affective to insulate the inside of
the door (on the back side of the exterior surface).
The second part of my project involves new speakers. The replacement door
panels I got have no speaker holes at all (I think they came out of an '80
air cooled with no door speakers), so I've got the option to install
speakers in the lower part of the panel, where there is a larger cutout in
the door. I'm hoping I can fit 6.5" speakers down there. Has anyone here
been successful doing this?
Thanks!
Jon