Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2011, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 26 Jan 2011 09:18:59 EST
Reply-To:     VWBrain@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Dearing <VWBrain@AOL.COM>
Subject:      Re: Oil leak...
Comments: To: a.robinson.lists@GMAIL.COM
Content-Type: text/plain; charset="US-ASCII"

In a message dated 1/25/2011 7:01:24 P.M. Eastern Standard Time, a.robinson.lists@GMAIL.COM writes:

Remove 2 hoses going to cooler (They should come off as I just did the WP a while ago) and drain coolant

this job can be done without removing these hoses. Use a large ezout to remove the stand pipe , then lower cooler enough to remove o ring seal and replace. whole lot easier and quicker later mark d


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.