Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2011, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 28 Jan 2011 08:13:24 +0700
Reply-To:     Frank Condelli <ralanen@AOL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Frank Condelli <ralanen@AOL.COM>
Subject:      Re: Door wiring repairs was Re: Fwd: Power Lock Trouble
Comments: To: David Beierl <dbeierl@attglobal.net>
In-Reply-To:  <4d3eddd1.9279e60a.4cc3.6ba4@mx.google.com>
Content-Type: text/plain; charset=us-ascii

A much easier way. Leave the tube ends in place, cut off the bellows part completely and discard, make your repairs, install a suitable sized piece of split loom so that it hooks up with the ends if the tube that is still there. This way you can get int to make repairs anytime, EASILY !

On 2011-01-25, at 9:27 PM, David Beierl wrote:

> Volks, if you have to get inside that rubber tube between cab and door you can unseat it at both ends and scrunch it up to get the access you need. *Far* superior to slitting it. But when you run your new wire, for heaven's sake do what I did not, and pass a fishing line along with the wire; because re-seating the tube end inside the door is an absolute bugger. I finally succeeded by compressing it very hard with electrical tape, shoving it into the hole and then pulling the tape off from inside, then easing it back so the lip engaged the hole in the sheet metal. > > Before I remove that end again I'll try to pass a fishing wire, but I'm not extra hopeful. Ten seconds worth of thought and a piece of string when I had the thing open would have saved a lot of trouble for next time. > > Yours, > David >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.