Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2011, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 23 Jan 2011 10:33:56 -0500
Reply-To:     craig cowan <phishman068@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         craig cowan <phishman068@GMAIL.COM>
Subject:      Re: 1.9 Running issues when wet out
Comments: To: Larry Alofs <lalofs@gmail.com>
In-Reply-To:  <AANLkTimubOKy6_=hwrS-idDAAheDbDGUwZDmht1g0JNf@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

You mention that there's no difference whether the O2 sensor is hooked up or not. THAT is the sign that the O2 sensor isnt working. That means even when it's "plugged in" it's not hooked up. So, it runs the same whether you unplug it or not. I am weary of the O2's on all 1.9s. They're a weak link and worth further consideration.

And yes, exhaust leaks can cause it to run like total crap, as well as be bad on your engine and destroy the O2 sensor.

-Craig

On Sun, Jan 23, 2011 at 7:59 AM, Larry Alofs <lalofs@gmail.com> wrote:

> When it's running OK take a spray bottle and mist the ignition wires, > distributor cap, and coil, etc. with water. If you do this in the > dark, it will be easier to see any arcing that happens. Might also > spray around the O2 sensor. > Good luck, > Larry A. > > > On Sat, Jan 22, 2011 at 6:10 PM, Jeff Lincoln <magikvw@gmail.com> wrote: > > OK, I've been dealing with this for some time now. When it rains (snow > > doesn't seem to bother it) a medium to hard rain I can get about 15-20 > > minutes down the road before rough running and eventually the engine just > > dies out. > > > > Cap, rotor, plug wires are all new. New Temp Sensor too (because previous > > diagnostics had proven it was a bit wonky). > > > > Everything in m's y gut tells me this is an electrical issue but I don't > know > > for sure and even if I did I don't know where to start. > > > > When this happens if I let the bus sit for a day I can get it running > again > > - but it takes a lot of messing with it - it will not idle at first, then > it > > will run rough and stall - each attempt getting longer and longer until > > eventually I am able to keep it running and it recovers and runs fine. > One > > other thing during the rough running period (when the problem starts and > > after it has sat and I am trying to get it going again) is that if I give > it > > any gas at all it will stall immediately - eventually of course it is > fine. > > > > I suspect by the way it acts after it has sat that it eventually gets > better > > becuase whatever is wet is drying off more and more. Then again I don't > > really know anything. > > > > Any advice at all pointing me in ANY direction at this point is welcome. > > > > -- > > Thanks, > > > > Jeff > > '85 GL (Gertie) > > '90 Carat (Grover - the noble parts donor) > > '86 (We call this one Scrap) > > '78 Bus (Melissa) Patty's Bus > > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.