Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2011, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 30 Jan 2011 10:00:30 -0800
Reply-To:     Don Hanson <dhanson928@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Don Hanson <dhanson928@GMAIL.COM>
Subject:      Re: Climbing
Comments: To: John Reynolds <transporterjr@yahoo.com>
In-Reply-To:  <248638.38984.qm@web110416.mail.gq1.yahoo.com>
Content-Type: text/plain; charset=ISO-8859-1

The thing is to NOT lug the engine. Nor run it at redline for hours on end. But lugging it...think about the stresses! When the cylinder fires...something has to move quickly...the piston. When you have a 4000+ lb vehicle with just 4 pistons trying to move all that mass...there can be some huge loads created, especially if you've selected a gear that make the driveline move the vehicle a long distance for each time the cylinders fire..(a high gear/low RPM) Now big trucks are built with that in mind...given very strong internals and ratios that allow big torque to come from very low rpm...But a little 2 liter VW motor....they don't have the strength to be floored at 500rpms without over-stressing the rods, the pistons, the bearings, etc. I cringe when I see or hear people going from 15mph to 80mph in 4th gear in a manual tranny in a VW...Or when they just sit there going uphill in 4th until their speed drops to about 20 and the van starts bucking.... I have never driven a WBX motor van..and I know they are meant to be lower rpm than other VW motors...but I'd follow Scott's recommendations..don't floor it or lug it...keep it around 2000rpms.

Don Hanson

On Sun, Jan 30, 2011 at 5:20 AM, John Reynolds <transporterjr@yahoo.com>wrote:

> "The aluminum/ magnesium alloys in the ACVW engine reach their elastic > state at these higher operating temps. They over-grow, stretch, warp and > will NEVER go back to their original shapes and sizes." > > Not to be picky, but that would be plastic state where things don't rebound > back to original dimensions. Probably meant elastic limit - beyond that > you are into plastic land - not a happy place with a VW engine. LOL > > Good analogy to the bike- I still see people pedaling in high gear all the > time - spin baby, spin! > > John >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.