90 MV, 2.1 No Clock & No Temp Gauge? I've broken something! I was messing with the Gauge Cluster main plug wires ( think there's about 9 of them in the plug ) and I think I must have shorted something out? I believe I had the first blue wire and the second yellow wire switched and now, I have no Clock and no Temp Gauge? The Temp Gauge light flashes the 6 or 8 times and then goes out as it should. But the Temp Gauge is pegged at the bottom and I have no clock. Fuel Gauge Works! Oil light works. Battery light comes on. I switched out a known good Cluster from another 90 and Same Results. I also installed a different temp 1 sensor and a different coolant tank sensor. But I feel the problem is in the wiring. I checked the fuses and did not see any of them blown. Could they be powered by a relay that is now bad? I would think it's the Voltage Stabilizer, but everything works when I replace the tester cluster back into the 91. Any help is very much appreciated ! Thanks, Clint |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.