Hi all. Was futzing around cleaning up and pulled some CV's off to inspect. (for the record they were all badly pitted) If this has been documented here, forgive me but..... My 1 - 5/16" opening Pittman Arm puller just fit over the CV cage/hub. I put a socket between end of puller and drive shaft for last bit, but it worked fine. pic of similar: http://www.matcotools.com/ProductImages/PA80_thumb.jpg This and the smaller version are useful for other front end work.
Neil. -- Neil Nicholson '81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/ http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.