Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2011, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 18 Mar 2011 09:00:21 -0700
Reply-To:     Stacy Schneider <vwcrewman@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stacy Schneider <vwcrewman@GMAIL.COM>
Subject:      Windshield
Content-Type: text/plain; charset=us-ascii

If you are using a new seal that all of the vendors sell , be ready for a fight . Lube both the body and the seal . I usually get the bottom and sides set and then go about working the top in with a tool while pressing and gently beating on the outside . Make sure that the lip of the seal is up Against the pinch weld before pulling the strong . The guys at G/W say they break a few windshields trying to install these seals . Good luck and keep the name of a pro near by.

Stacy

Boy Scout " Wood Badge " trained.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.