I finally replaced my leaky axle flange seal this weekend. Mike, I took your advice and used Hylomar. I was not at all prepared for how fast that stuff sets up! With Ultra Black you have a a little time to wiggle the seal in, but I found that the Hylomar was very sticky and tacky and made the seal VERY resistant to going in. I'm hoping that it seals things up better than the Black, though (no leaks so far.) Thanks for the tip. Joe T. '85 Wolfsburg Westy Subie 2.2 On Fri, Nov 19, 2010 at 3:20 PM, Mike S <mikes@flatsurface.com> wrote:
> In my experience, Hylomar works much better than silicone. It stays pliable > and sticky. > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.