This was also posted to the samba, here: http://www.thesamba.com/vw/forum/viewtopic.php?t=458028 Figuring that anything I run across has to have happened many times to others, anyone have this problem? The lower ball joint is pressed into the spindle, looks well-seated, and clipped in at the bottom. The tapered shaft though, doesn't come even close to reaching it's shoulder. I've already ordered another lower ball joint, and will test fit this one to the lower arm before having it pressed into the spindle, but it seems strange if the manufacturing specs could be that far off between units. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.