Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2011, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 28 Apr 2011 16:38:03 -0500
Reply-To:     John Rodgers <inua@CHARTER.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Rodgers <inua@CHARTER.NET>
Subject:      Re: Can't find the jack
Comments: To: dingham605@AOL.COM
In-Reply-To:  <8CDD3FD573481E3-1098-57423@webmail-m095.sysops.aol.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

I recommend the OEM type. It is so very easy to use. The pitch of the screw in the jack makes it easy to turn - even though it takes many turns, and it is designed specifically to fit the van at the correct lift points to get the job done. Anything else is a definite "make-do" device. I beleive in the old principle of the right to for the right job - and the OEM jack is just such a case. One caveat, however - always take with you a couple of blocks of 2X6 or 2X8 lumber about 12 inches or 16 inches long upon which to rest the foot of the jack when in use. Having a couple of chocks along too would be a good thing as well, to prevent inadvertent rolling. I always carry at least one jack stand as well. I never trust a jack of any kind when I'm doing any kind of work on a van - even changing a tire. Raise the vehicle with the jack, slip the jack stand under a suitable point under the van, let the vehicle back down on the jack stand to stbilize it, then change the time. It's not that much trouble. Better safe than sorry.

BTW - I keep a spare OEM jack in the shop to use when I'm working on the van at home. And, there is a list member who sells a lift extender for use with a Hi-lift or Wagon-Wheel Jack if you use one, say at home for your own maintenance.

John

John Rodgers Clayartist and Moldmaker 88'GL VW Bus Driver Chelsea, AL Http://www.moldhaus.com

On 4/28/2011 3:52 PM, Susie Ingham wrote: > Hi All- > > > Is the jack for the vanagon normally under the rear seat ? ( 84 Westy) if so, ours is MIA. > Do you recommend the OEM or this scissor type? > > http://www.busdepot.com/details.jsp?partnumber=237011031 > > thanks! > > Ps We did change the oil and took our van out for a good drive today-- no issues-- plus turned over to 309,000 miles! > > Susie > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.