|
Upon rethinking, I maybe the slave bleeder is the highest point at the rear. I'll look next time I have the engine cover off.... Line screws into the side or the end of the slave? Don't remember.
On Apr 30, 2011, at 4:21 PM, Paul wrote: > "The high points are at the master cylinder and just before the > slave." > > The line on mine actually come in below the slave and bends and > levels out > at the point where you tighten the fitting. Maybe some redid it that > way |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.