At 12:18 PM 5/3/2011, David Beierl wrote: >At 08:38 PM 4/21/2011, Mike wrote: >>Maybe, I could set up a bench rig using a variable speed Dremel motor with a > >Dremel way way too fast. Think 3/8 electric drill. You need around >800 rpm, remember. Before you mess with any of this, check your zero. There's a mark on the gauge face, below the stop pin. Remember the needle is very brittle, and also use the two-spoon technique to lift it off the shaft if necessary. The shaft is hardened and brittle and unforgiving. Yrs, d |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.