>Putting Sally's "new" transmission on and haven't been able to get >the input shaft to enter its pilot hole. Clutch pilot tool shows >clutch centered perfectly but the closest I've been able to get the >flanges is an inch (ring gear just out of sight in the bell >housing). Does that indicate a complete miss or that the rounded >front of the shaft is entering Mark Drillock was the first of several people to remind me that the splines on the shaft had to line up with the splines on the clutch...transmission in gear, a little tweaking of the crank pulley and in she went. Thanks, David |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.