Date:         Wed, 11 May 2011 19:28:30 -0700
Reply-To:     neil n <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil n <musomuso@GMAIL.COM>
Subject:      Re: Front end suspension
In-Reply-To:  <BANLkTi=jdNr=xw_0rVi9a4XikO8fCegCaw@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

I was careful to make sure piece of pipe et al were as square as
possible.  Pretty sure if they aren't, this might risk pressing part
in cockeyed. A piece of 3/4" plywood was used to back the other jaw.

Neil.

On Wed, May 11, 2011 at 7:25 PM, neil n <musomuso@gmail.com> wrote:

> I pressed old parts out and new in, with vice, piece of exhaust pipe
> and steel plate to back up part and pipe.


--
Neil Nicholson '81 VanaJetta 2.0 "Jaco"

http://tubaneil.googlepages.com/

http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.