Date: Fri, 27 May 2011 09:04:23 -0700
Reply-To: Zeitgeist <gruengeist@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Zeitgeist <gruengeist@GMAIL.COM>
Subject: Re: Torque spec that requires calibrated fingers
In-Reply-To: <BANLkTim7272HkjVSNrp7Aw+RsS3Oq08UGg@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1
It's all in the wrist. Having wrenched on German fasteners for over 30
years, I've acquired a feel for proper specs per 6mm, 8mm and 10mm, etc.
fasteners. Even if using a long handled wrench, I always apply force as
close to the fastener as possible for smaller pieces and only use the full
length and my massive spaghettis for the larger items. It's a zen thing.
My heavens, I've gone Pirsig on ya'll
Use the force (lightly) Luke
On Fri, May 27, 2011 at 8:32 AM, Jim Felder <jim.felder@gmail.com> wrote:
> He's kinda right. The notion that you would torque a fastener by hand runs
> counterintuitive to owning the wrench, in a way, but there is some truth to
> it. You can learn what a certain pull is if you pull it enough. Of course
> you have to figure in the length of the wrench you are using, but you learn
> that too. My dad used a torque wrench only a couple of times in my life
> that
> I saw; the other times he was "torquing by feel." He sure worked on a lot
> of
> stuff torquing by feel. He also snapped off more than his share of bolts. I
> use a torque wrench were I can, and by feel where I can't.
>
> You figure it out the same way you can tell what something weighs without
> using a scale just by hefting it. Same thing.
>
> Jim
>
> On Fri, May 27, 2011 at 9:13 AM, Rocket J Squirrel <
> camping.elliott@gmail.com> wrote:
>
> > tencentlife's adapter kit for connecting a adapter which allows a fellow
> > to mount a oil pressure gauge sender alongside the stock oil pressure
> > warning light sender has this to say about torquing:
> >
> > "Torque recommendations are meant as relative guides, it will not
> > generally possible to actually use a torque wrench on the fittings in
> > this installation."
> >
> > "...Tighten the fitting carefully, it has a taper thread so it will seal
> > into the case hole with moderate torque, generally less than 8-10ft.lb."
> >
> > and
> >
> > "The compression fittings should attain a good seal with only
> > 10-12ft.lb. of torque, so don't overdo it."
> >
> > I'm assuming that some of yinz have fingers calibrated after many years
> > of experience. Is there any wisdom that can be shared here?
> >
> > -- RJS
> >
>
--
Casey
|