tencentlife's adapter kit for connecting a adapter which allows a fellow to mount a oil pressure gauge sender alongside the stock oil pressure warning light sender has this to say about torquing: "Torque recommendations are meant as relative guides, it will not generally possible to actually use a torque wrench on the fittings in this installation." "...Tighten the fitting carefully, it has a taper thread so it will seal into the case hole with moderate torque, generally less than 8-10ft.lb." and "The compression fittings should attain a good seal with only 10-12ft.lb. of torque, so don't overdo it." I'm assuming that some of yinz have fingers calibrated after many years of experience. Is there any wisdom that can be shared here? -- RJS |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.