Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2011, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 24 May 2011 17:49:49 -0700
Reply-To:     Alistair Bell <albell@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Alistair Bell <albell@SHAW.CA>
Subject:      Re: Fastener wizard?
Comments: To: Rocket J Squirrel <camping.elliott@GMAIL.COM>
In-Reply-To:  <1306282197.21047.135.camel@TheJackUbuntuNetbook>
Content-Type: text/plain; charset=US-ASCII; format=flowed; delsp=yes

Ramblin' Jack...

do I get it right, a bolt with a hole drilled radially at one end?

Jeez, what will they think of next?

:)

cut the bolt and drill a new hole...

alistair

On 24-May-11, at 5:09 PM, Rocket J Squirrel wrote:

> I'm holding in my hand a bolt (holds bolt up to monitor so everyone > can > see). It is a 5/16-18 carriage head bolt about 1-1/2 inches long. So > far, so normal. But at the tip end (not the head end) there is a > 3/16'' > hole drilled crossways, perpendicular to the axis of the bolt. This, > for > inserting a padlock. > > I need a shorter version of this bolt. I can't cut off the drilled end > because the shorter version also needs a cross-drilled end


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.