Date:         Sat, 28 May 2011 09:58:22 -0700
Reply-To:     Steve Young <sja_young@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Steve Young <sja_young@YAHOO.COM>
Subject:      Source for Sliding Door lower Guide Bearing
Content-Type: text/plain; charset=us-ascii

Hi list,

My 84 westie had the ball race collapse on the vertical lower guide bearing that
sits at the bottom of the sliding door. Its NLA at local dealer and not I'm
finding anywhere online. Checked out skateboard bearings which can be
substituted on other part of sliding door mechanisms on later vans, visually, ID
looks about right, but OD is too small.

Anyone on the list had this problem and found a good solution?

Thanks,

Steve

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.