--- On Wed, 6/1/11, Werner Schink <werner.calnr@SBCGLOBAL.NET> wrote: > speaking of rear tables -- drilled a bit of an indentation in the rear > table pipe where the securing screw contacts the pipe. used to have a > problem with the table getting loose and swinging around That's funny, I was just looking at that yesterday. But on my 87 there is a plate inside the mount, so the screw on the end of the knob pushes against the plate and that tightens against the table leg. So I couldn't figure out how to make it work. My most appreciated thing is fixing the cruise control. No more sore knee or ankle on long trips, and now I'm not watching the speedo constantly. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.