A thin wall deep 19mm opr 3/4 inch socket works nicely. I just tired it to be sure. If 'T2' means Temp Sensor II, and 19mm was mentioned.. and AC compressor being somewhat in the way .. with those hints it can only be a 1.9 2WD wbxr. the same sensor is used on syncro's .. but the AC compressor isn't near it of course. scott www.turbovans.com ----- Original Message ----- From: "John Lauterbach" <jhlauterbach@BELLSOUTH.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Sunday, June 12, 2011 6:22 PM Subject: Changing T2-sensor with air conditioning compressor in place
>I went out to my garage this morning with the aim of changing T2 only to > find that my 19-mm open end wrenches were to big to fit the space and my > 19-mm socket was too shallow to get around the electrical connector and > on to the nut. It looks like job could be done with a cut-down 19-mm > open end wrench. > > Is there a secret tool for this job? Last time I installed T2, the > engine was out of the van. > > John |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.