I was hoping to take the bulb and light switch out of the equation, so what I did was unhook the driver's dome light completely. I just tested the two wires coming up the A pillar which feed the light (red and brown), of which one ran straight to ground behind the fuse panel and the other ran to the T2c/1 connector which goes on to the radio and stock cig lighter port (I think???) This is what showed the continuity I'm not sure of, but is that just running through the radio and cig lighter circuit normally or would my worry or a short somewhere with these results be founded? Thanks, Reid
Date: Sun, 19 Jun 2011 08:04:51 -0400 From: Edward Maglott <emaglott3@GMAIL.COM> Subject: Re: Dome circuit wiring If I'm reading you right, sounds like the continuity is from the bulb.... if it's still in the socket of the dome light. Edward
At 09:59 PM 6/18/2011, reiderikson wrote: > blah, blah... > Unhooking the wires from the light and testing the red (I think > T2c/1 from Bentley 97.210) and brown (#30 grounded "near relay > panel" same page) above the driver's door shows the same continuity as well. > > Little help here? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.