Date:         Sat, 18 Jun 2011 13:09:10 -0400
Reply-To:     John Lauterbach <jhlauterbach@BELLSOUTH.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Lauterbach <jhlauterbach@BELLSOUTH.NET>
Subject:      Resoldering PCB on Bosch ECU for 1.9L engine
Content-Type: text/plain; charset="UTF-8"

I plan on resoldering the critical connections on the PCB on Bosch ECU
for 1.9L engine.  Circuit board has number 2288325840-4/  on one corner.
As I understand, the critical points are where the pins from 25-pin
connector is soldered to the PCB.  Is this correct.  The board appears
to have been coated after the board was soldered.  Does this coating
give any difficulties for resoldering the pins.  Are there other points
that need to be soldered?

John

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.