Date:         Wed, 29 Jun 2011 11:27:54 -0700
Reply-To:     Jeffrey Vickers <jeff@VICKERSDESIGN.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jeffrey Vickers <jeff@VICKERSDESIGN.COM>
Subject:      Re: Solar Panel outdoor electrical connect
In-Reply-To:  <20110629030141.7441837D71D@izzy.vickersdesign.com>
Content-Type: text/plain; charset=US-ASCII; format=flowed; delsp=yes

That's what I do. My Anderson Powerpole connectors are right behind
the license plate door. I plug 50 ft of BIG speaker wire into those
and put my panels in the sun. My aux battery is under the rear seat so
I ran the leads through the firewall and out through the engine
compartment to the license plate door. The only hole I had to drill
was under the rear seat where it is well protected and easy to
occasionally check for rust. Why put another hole in the outside of
your van when you don't have to?

Jeff in Marin



On Jun 28, 2011, at 7:59 PM, Automatic digest processor wrote:

> Date:    Tue, 28 Jun 2011 19:19:43 -0700
> From:    Richard Koerner <rjkinpb@SBCGLOBAL.NET>
> Subject: Re: Solar Panel outdoor electrical connect
>
> Would it work to "dangle" it out of the license plate door?=A0 That
> is, kee=
> p it bundled neatly, but then an easy connection and you're good to
> go.=A0 =
> Us "non-Westy" guys do that to make a clean 120 VAC installation for
> when i=
> n campgrounds with electric power.=A0 (Not that I've done it...still
> route =
> the trusty 35' extension cord out the driver's door footwell and let
> the ru=
> bber weatherstrip compensate; but, one of these days...)
>
> Rich
> San Diego