At 03:38 PM 7/17/2011, Troy wrote: >I was actually looking for a different design altogether rather than >a fix for the rubber. Along those same lines, a person could use >heat shrink tubing. There is also paint on electrical tape. I did a >little bit of searching and found this simple clamp, although I'm >not sure it would be strong enough. From the look of the design it >might slip right over the gutter rail. >See: http://www.dripirrigation.com/drip_irrigation_parts/117 Those aren't load-bearing. For a start you can move the clamping bolt closer to the working end. You'd be surprised how much difference that makes. I've already suggested that to Ron. Yours, David |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.