Now if you get the "big nut" off, hope you can get the drum off also. BTDT w/ a splittie! Now that is a different tool, but well worth having the OG VW shop tool which weighs a ton, but sometimes the only thing that will work? YMMV, Mr. BZ-6 months, PB Blaster, Drum Puller, torch, 4' cheater bar w/ 3/4" drive, whatever it takes
On Jul 19, 2011, at 2:36 PM, mark drillock wrote: > Either get the 46mm hammer tool for the end of the 1/2" breaker bar or > get a big 3/4" bar and 46mm socket. I use the big set at home and carry > the hammer tool on the road. Here is the hammer tool. I have been using > them for 30+ years on VW Bus rear axle nuts. > > http://www.van-cafe.com/home/van/page_1216_787/46mm_axle_nut_tool.html > > Mark > > > Don Hanson wrote: >> didn't work.... broke the bar. I should just 'bite the bullet' buy a $3/4 >> drive breaker bar, but they are so expensive when you use them once every >> few years....cheaper I guess that breaking 1/2 inchers and then buying >> one.... |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.