dear tom can these be manufactured in a hydraulic shop what they do is cut off your good ends and swedge on high pressure fittings just like rebuilding a high pressure power steering hose regards On Fri, Jul 15, 2011 at 6:34 PM, Tom Stone <tstone8359@aol.com> wrote: > Where does one obtain the proper "bubble" hydraulic lines for the clutch? > I need all the pieces from the master cylinder to the slave cylinder. > Don't see them on the usual list vendor sites. > > > Tom >
-- roger w From Proverbs: Under three things the earth trembles, under four it cannot bear up: a servant who becomes king ... ---------------------------------------------------------- Explore printed work at: http://www.prliving.ca/ View the growing list of video work at: http://www.prpeak.com/articles/2010/11/29/multimedia/video/doc4c62e5f80d228504902172.txt |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.