Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2011, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 23 Jul 2011 17:38:27 -0700
Reply-To:     Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject:      Re: 84 westie at 10 miles/gallon
Comments: To: David White <sirgrumpsalot@GMAIL.COM>
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
              reply-type=original

re the temp sensor II always reads HOT based on the Bentley test

sounds wonky to me. I wouldn't do anything else until that was working right. They're a weak link almost.

Alligator clip !???? no no no. it's an input to a computer for goshsakes. that connector also is a weak link. - the stock one after many years.

I'd check that timing is advancing properly too.

coolant seldom gets into the oil on waterboxers.. but you can have all kinds of coolant issues besides that one.

is it running up to temp ? very important. Some people think 1/4th on the gauge is good ..it's not. as I said ..if temp sensor II shows only one resistance..toss that one and get another one to start with.

and there is a whole thing about shorted oxygen sensor signal ..but I have not run into that myself. Scott www.turbovans.com

----- Original Message ----- From: "David White" <sirgrumpsalot@GMAIL.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Saturday, July 23, 2011 3:32 PM Subject: 84 westie at 10 miles/gallon

>A recent purchase, came with the low mileage > New O2 sensor > New injectors > Replaced throttle body with one that I knew was good > New spark plugs and all the other small stuff > cylinder pressure 110-125 across all 4 > swapped AFMs with my other vanagon that gets better mileage > the connector clip on the temps sensor II to the ECU is loose so it's > zip-tied in place > the temp sensor II always reads HOT based on the Bentley test > timing seems OK, will get up and go when needed > no coolant in the oil > > Any help would be appreciated.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.