I think most aftermarket wire sets now come this way. Not that this end is now missing the resistor that was part of the OEM angle connectors. Dennis -----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Karl Mullendore Sent: Wednesday, August 10, 2011 10:21 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Go Westy tune up kit IIRC, at one point Bosch was making plug wire sets with an end connector that would work with both cap types. It had the normal 'old style' end that clips in place but the center of the clip had an extra part that would also grab the threaded post of the 'new' style caps. Is this perhaps what was supplied and you might not have noticed? Karl |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.