Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2011, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 8 Aug 2011 17:58:06 -0500
Reply-To:     John Rodgers <inua@CHARTER.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Rodgers <inua@CHARTER.NET>
Subject:      Re: Oil plug gasket -- FLAPS?
Comments: To: Tom Lambas <twlambas@GMAIL.COM>
In-Reply-To:  <CAF7dTYWO_v+KZjdUtGN212d+Y4pCA5JMD8JC6xPa9Rub4LSVhA@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

I want to know just what contitutes and oil plug gasket. I started out in my current van - before I knew a whole lot about them - with a crush type copper gasket - a folded copper ring with a piece of somekind of crushable fiber squeezed inside. When the oil plug was tightened, this material wash crushed down, making for a very good seal. Several oil changes later, by garages and other nether places - I discovered the crushable had been replaced by a solid copper washer - and they called that an oil plug seal. Well, I beg to differ. In my experience - and granted, it was in the aviation field - a crush gasket was just that - crushable as I described, and to be replaced at each oil change. It was somethign you didn't re-use. I have ordered "Oli Plug Gaskets" from list vendors, only to get that copper washer. Not cool! Was what I had in the beginning a fluke? The van was used, after all, and perhaps someone put that crushable gasket there in place of the copper washer - I don't know. But i would like to know what is properly called for and if it's not the copper washer, then where do I get what is called for.

Thanks,

John

> John Rodgers > Clayartist and Moldmaker > 88'GL VW Bus Driver > Chelsea, AL > Http://www.moldhaus.comMy local dealership still had them last time I checked. Maybe yours will > too. > On Aug 8, 2011 4:47 PM, "Rocket J Squirrel"<camping.elliott@gmail.com> > wrote: >> Is the oil plug gasket used on the 1.9L something I can hope the FLAPS >> will have, or do it be mail-orderish? >> >> -- >> Jack "Rocket j Squirrel" Elliott >> Bend, Ore. >> 1984 Westfalia. A poor but proud people. >> 1971 "Ladybug"-brand utility trailer, the Westralia. >> >> Sent from my kitchen. >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.