Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2011, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 11 Sep 2011 12:58:52 -0500
Reply-To:     David <dlwilhite@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David <dlwilhite@COMCAST.NET>
Subject:      Re: Mutilated woodruff key at crankshaft
Comments: To: Paul <wognacious@GMAIL.COM>
In-Reply-To:  <CAK8UGbS0W06LKUwSCbzTUZgPoe02SjpG7Tp-60mkGvuWrucvxQ@mail.gmail.com>
Content-Type: text/plain; charset=us-ascii

Paul,

Yours may be too far gone, but I once used a permanent loctite product (I don't remember which one it was) in an application like this and it held for a number of years. Try looking at this link. http://www.henkelna.com/us/content_data/192137_LT5338_Shaft_Repair_final.pdf

DLW

On Sep 11, 2011, at 12:21, Paul <wognacious@GMAIL.COM> wrote:

> My girlfriend has been driving my vanagon pretty much daily. Recently she > said that she thought something wasn't right back in the engine compartment. > Well she was right, the bolt that's supposed to hold the pulley in place had > worked itself part of the way out. Upon further investigation I discovered

> that the woodruff key was not in the slot, or what's left of it. It was kind > of in there on it's side and the slot is no longer a slot it's bigger than

> it should be. One side is square but the other side is not good. I don't > have the time or $$ to pull the engine out to replace the crank so I'm > trying to fix it the best I can and hope it will hold up for awhile. Has > anyone had this problem and if so what did you do? I've considered trying to > drill a hole through the pulley and into the crankshaft, tap it and run a > allen bolt/screw in to keep the pulley in place. Maybe make the existing > slot larger and make a bigger key. > Any help or insight would be greatly appreciated as I need to get the rig > back on the road. > TIA, > Paul > 85 WWW, 1.9L


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.