Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (September 2011, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Tue, 20 Sep 2011 18:06:56 -0400
Reply-To:   craig cowan <phishman068@GMAIL.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   craig cowan <phishman068@GMAIL.COM>
Subject:   Re: Transmission QuickChange
Comments:   To: Scott Daniel - Turbovans <scottdaniel@turbovans.com>
In-Reply-To:   <074a01cc77df$8b08e4d0$6401a8c0@PROSPERITY>
Content-Type:   text/plain; charset=ISO-8859-1

5 hours for a 2wd. Maybe 7 (over the course of 2 days) if it's your first time.

3-4 months for a syncro.

-Craig

On Tue, Sep 20, 2011 at 5:51 PM, Scott Daniel - Turbovans < scottdaniel@turbovans.com> wrote:

> your time budget sounds all right to me. > Up to five hours. > > > > ----- Original Message ----- > From: "John Jensen" <bluesbug@VERIZON.NET> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Tuesday, September 20, 2011 1:35 PM > Subject: Transmission QuickChange > > > Oh! I just went out and pulled my spare transmissions from my parts pile. >> I forgot completely about the clutch, the starter and the CV joins and >> axles. >> I knew there was a reason I was putting this off till I could do a >> complete job of it. >> >> "This list has done itself proud once again, by discussing the topic >> fully and sharing knowledge and information. >> My decision making about my upcoming trip isn't any easier than at the >> outset, but at least I'm better informed. >> In my case the issue of the damage to the transmission isn't such a big >> deal because the bad one isn't the one I >> would re-build in any case. Just another small question to the >> experienced members in this group. How much time >> would you budget to swap out the tranny by yourself, sitting in the >> driveway...I'm thinking it shouldn't be too hard. Just block up the >> engine, >> disconnect the linkage and undo the four bolts to the engine and lower >> it down with a floor jack. (three hours Max). >> Put in the replacement and adjust the linkage...Five hour max. So a >> busy day...two if things get weird. Reasonable?? >> Could probably do the whole thing in two hours if things went smoothly. >> Shame not to do the clutch and flywheel at the >> same time, but skipping that. " >> >> John Jensen >> johnjensen@johnjensenartist.**com <johnjensen@johnjensenartist.com> >> http://www.johnjensenartist.**com <http://www.johnjensenartist.com/> >> bluesbug@verizon.net >> >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.