Date: Thu, 29 Sep 2011 16:59:47 -0400
Reply-To: Ken Wilford <kenwilfy@COMCAST.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Ken Wilford <kenwilfy@COMCAST.NET>
Subject: Re: Van won't run right - troubleshooting help
In-Reply-To: <4E84CD62.1000204@planetmind.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
David, the first thing you need to look at is what is happening when it
won't start. If it has spark but won't fire then you want to check to
see if your injectors are spraying. If they are working then put your
hand in front of the tail pipe to be sure that the exhaust is getting
out (no clogged cat) when you crank the van over. If all of these
things are working and it still won't start then it is possible that
there is a sender in the FI system that is causing the van to flood
out. Most of the time if this is the case with your van, it is the Temp
II sensor on the thermostat housing. You can test for this by
unplugging it and then using a paper clip to jumper the two prongs in
the plug to each other. Now try to start the van. If it starts right
up then you know that it is the temp II sensor that has gone bad. If it
still won't start, try unplugging the oxygen sensor. The van will run
fine without it plugged in and sometimes they can fail and cause the van
to run super rich (flooded).
If none of these work, I would check your spark plugs for fouling and
proper gap and also your cap and rotor. If you go one thing at a time,
step by step, you will find the problem.
If you need any other help please let me know.
--
Thanks,
Ken Wilford
John 3:16
www.vanagain.com
Phone: 856-327-4936
Fax: 856-327-2242
On 9/29/2011 3:56 PM, david hardy wrote:
> So I have this issue with my '86 Westy that's got me
> stumped...yesterday it started missing a
> tad, then just it quit on me in the middle of traffic (luckily a block
> from my house) after
> running great all day. It would turn over but just not fire. After
> tons of cranking I got it
> started again, but it was running really rough, no power, very
> unbalanced, coughs and sputters
> when trying to rev it. It seemed to go between running perfectly then
> terribly every few
> seconds. I got it home and it's getting spark, fuel pump is working
> (pump runs and there's
> pressure in lines). Have also have a 1990 Westy, so I swapped out the
> AFM (no change), coil (no
> change), ECU (no change) and the distributor (no change). Funny thing
> is, this morning, it
> started perfectly, but then immediately started running really rough
> like before. And now it
> won't start (no ignition at all) again.
>
> I've had this issue a few times before, but it's always cleared itself
> up within a minute or
> two. Now I guess whatever was failing has done so for good. Anyone
> have any ideas?
>
> Thanks in advance.
>
> David
>
|