On Oct 7, 2011, at 4:57 PM, Gilles H Turmel wrote: > Do I drive the spring pin top-down or bottum-up for an easier install? (roll pin installation orientation) I re-installed the pin downward, the flared end up. With all the movement of the arm, I felt that it "could" work its way out if driven upward with the flared end downward, and unlikely that would happen with that end up. So far, so good and that was 7 or so years ago. It's also easier to install the pin that way, from the top. bob |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.