Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2011, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 12 Oct 2011 08:50:54 -0700
Reply-To:     Daniel Rotblatt <d.rotblatt@VERIZON.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Daniel Rotblatt <d.rotblatt@VERIZON.NET>
Subject:      Re: Auto Transmission slipping
In-Reply-To:  <2ACA97189C2EF74D9A8E287072A52D198E32628D0A@suex07-mbx-03.ad.syr.edu>
Content-Type: text/plain; charset=windows-1252

Thanks Dennis and Daniel - both good advice. I'll try the high milage ATF additive and maybe that will help on a seal. Meanwhile, I'll start pricing a rebuild and find a good mechanic for that.

Thanks again,

Dan Los Angeles, CA "Winky" the '85 Westy Weekender

On Oct 11, 2011, at 8:36 AM, Daniel O Stevens wrote:

> Your 2nd gear plunger could have aged/hard seals and taking abit more RPMs to pump sufficient fluids to engage the 2/3 gear set. > This can be serviced in the vehicle by fairly normal but competent hands. > Search on the vanagon forum over on www.thesamba.com and there’s some threads on the 2nd gear plunger. Should offer seal part #s and direction. > > You can also use high milage ATF additive, these will often have a rubber seal conditioner if it’s not too late. > If it’s only on turns and only after the lvl was reset, then possibly the AT prefers a little more ATF in the pan for one reason over another. > The fluid can foam if low (or high) and that causes many issues with air suspended in the fluid. > > Hope this helps some.. best of luck > > Dan in Syracuse. > > > Date: Tue, 11 Oct 2011 01:26:47 -0700 > From: Daniel Rotblatt < > > Subject: Auto Transmission slipping > > Thought I could get some input on how to milk as many miles out of my > tranny as possible, or maybe there's a fix without a rebuild. > > It's an '85 westy, with a 3 speed auto transmission. It seems to > slip most when accelerate after I go around corners, otherwise it > works fine. Fluid was a bit high when I bought the car last May, but > when i had work done on it this summer they replaced all the fluids > and the level is fine now except it seems to slip a bit more. Last > time I drove it I noticed the trans slipping after only a 5 minute > drive back from a store - so it wasn't too hot. > > Thanks in advance... > > Dan > L.A., CA > '85 Westy Weekender > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.