I was trying again to see if I had any current draw so did some internet sleuthing to help me figure this out. I can rebuild engines fine, tune motorcycles, etc, etc, but when it comes to multimeters I am an idiot. I think I did it right, but want some backup on this. I put my MM between the + terminal on my new battery and the + cable. I then set my RadioShack MM to the notch marked 200 DCmA which also had a solid line beside it with 3 dots under it. I then took the reading, and it said 00.0 ??? I reversed the leads and it then said -00.0 Does that mean I have no current draw at all?? I am lost, because I have a small digital volt gauge plugged into the lighter that MUST be drawing something?? The MM reads voltage across the battery fine, at 12.74volts, so I think it's working fine. What am I doing wrong?? Courtney |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.