Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2011, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 2 Nov 2011 09:06:19 -0700
Reply-To:     Roger Whittaker <rogerwhitt1@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Roger Whittaker <rogerwhitt1@GMAIL.COM>
Subject:      Re: it's cold in MT and my van won't start
Comments: To: Jonathan Edwards <edwards151@gmail.com>
In-Reply-To:  <CAP54mAG-_ozO169xKN1CQdDXwKrVDNPsP3cz8TiBRS=z4tDEng@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

dear ether DONT DO THAT

try tightening your v belt .. that means slack off alt and use a bar to pull tight then retighten ... you must use the the ancient german spec gü**tnticht

because i often work alone on my ride ... i use a piece of parachute chord and tie that to a place on the body >opposite the alt and in a double so i can use a short screw drive to tighten up by tightening the chord like a turn buckle > then i retighten alt vangon is always much happier after this ... remember only gütnticht so you do not mess up millwrights carefull line up of pully and engine crank

this is your mission jim if you choose to accept it this message will not self-destruct in 5 seconds regards

On Wed, Nov 2, 2011 at 8:37 AM, Jonathan Edwards <edwards151@gmail.com>wrote:

> I tried to start up my '85 weekender this morning (19 degrees F in > Bozeman) and she turned over fine and ran for a bit, then kind of > bogged down and died. I repeated a few times with my foot on the gas, > trying to keep the RPMs high but the same thing happened. I've noticed > on other cold mornings (not this cold) that the van will start fine, > but I have to keep my foot on the gas petal slightly to keep RPMs up > or it will die, until it gets warmed up. Ideally, I'd like to be able > to go out, start it up and let it run unattended for 10 minutes to > warm up (while I go back inside). There is some kind of a cold-start > valve that controls idle RPMs when the engine is cold, right? Sounds > like this needs to be looked at? But that doesn't explain why the > motor dies when I am physically there with my foot on the gas. > There's also the "thermo time switch" - maybe that has something to do > with my problem? I've got a Bentley, but have yet to have time to > really get into it and understand how to use it. Any help would be > greatly appreciated! > > Thanks > > Jon >

-- roger w From Proverbs: Under three things the earth trembles, under four it cannot bear up: a servant who becomes king ... ---------------------------------------------------------- Explore printed work at: http://www.prliving.ca/ View the growing list of video work at: http://www.youtube.com/user/LastonLastof#g/u http://www.prpeak.com/articles/2010/11/29/multimedia/video/doc4c62e5f80d228504902172.txt


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.