Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (November 2011, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 27 Nov 2011 17:35:34 -0800
Reply-To:     Don Hanson <dhanson928@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Don Hanson <dhanson928@GMAIL.COM>
Subject:      Re: Westy Weighed... Setting Corner Spring Rates
Comments: To: Michael Snow <slowmachine82@gmail.com>
In-Reply-To:  <4ED2CD8A.1080406@gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

On Sun, Nov 27, 2011 at 3:53 PM, Michael Snow <slowmachine82@gmail.com>wrote:

> I have the same problem, and would like to do something about it. > > T > What could be done to equalize the left and right loads at each end, > enabling the van to sit and ride level, while using matched springs on > each side and providing more neutral handling? If you could decrease > the right front load, the left rear load should also decrease without > leaning to the left, no? > > Mike >

Since ride height is not adjustable with stock Vanagon suspension...I used some aluminum to shim my van...to get it closer to corner balanced than it was..I think I added about 3/8" above my rear spring on the right side...When I got the van, the right rear would spin if you looked cross-eyed at a hill or gravel or sand....Shimming that wheel "down" helped a lot, good enough for a Campmobile/worker van/mobile dressing room. Despite what Scott says, I do NOT describe vanagon handling as 'sports car like' by any stretch of my imagination..... (grin) so 'close enough' regarding ride height is adequate for me... I do pay a bit of attention when I load up for a long trip..try to approximate an even loading ..Vanagons do not have very compliant suspension. The wheels have pretty limited range of motion...so a little change goes a long way to even them up. Remember, when you change suspension heights....you move things just half as far as they are 'out'...I am mixing metaphors...height weight up down heavy light......The best way to visualize how the wheels work in relationship to each other is to take two pencils and cross them at right angles in one hand....now, move that hand around and watch....you will see ...


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.