>Made by an AA airline machinist in Dallas, given to me by >Mike Boland who worked with the fabricator. >http://www.flickr.com/photos/syncronaut/6462855697/in/photostream/lightbox/ >Since I don't use the vent, that cap stays on as-is, held on with the wing >nut. >It's screwed on tightly so has never been kiped. ;-) As has already been >described in this thread, the SS vent plate was removed, center-drilled >and a small bolt put through it. No leaks. >Bob I haven't tried it, but here's a suggested place to start: http://www.ebay.com/itm/ALUMINUM-5-1-8-CARBURETOR-COVER-HOLLEY-EDELBROCK-/120821028676 Perhaps too deep, but you could trim it off. 5 1/8" diameter seems perfect. Regards, Vern |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.