Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2011, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 11 Dec 2011 20:01:09 -0500
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Rear Shocks, Syncro vs. 2wd-Feeling defensive here!
Content-Type: text/plain; charset="US-ASCII"

Folks, I am not saying that all modifications are a No-No! The original question was about using Syncro rear shocks in place of the proper non Syncro shocks due to those shocks being available. My response was to get the correct ones. Without making other modifications to compensate using longer shocks defeats the design of the shock length being the lower suspension limit. Over the years I have seen the drive shafts get pulled out of the CV joints, I the drive flanges ripped off the differential shafts, the rear springs fall out while on the road, etc. The last one though is usually due to the lower spring perch rusting off or aftermarket springs wearing thorough it.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Robert Stevens Sent: Sunday, December 11, 2011 6:55 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Rear Shocks, Syncro vs. 2wd

> you can adjust the limit to suit, that is the advantage. > > alistair > > > On 2011-12-11, at 2:28 PM, Dennis Haynes wrote: > >> So if you install a strap or other device to limit travel where is >> the advantage of the longer shock? >> >> Dennis

Not quite the same thing, but similar. I have 930's on my Syncro and put a modified spring perch on the rears that are heim-jointed, which allow the trailing arm to travel, without bending the spring longitudinally, it stays straight while the suspension travels up/down.

Because of an additional ride height of almost 2", I put a Pro Comp shock that is a 14", stock height is 12". We put the van on a lift and let the wheels go to full droop and could see that the splines on the axle/CV interface were too close to "too far", so put limiting straps on.

The end result has been very effective.

bob


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.