Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2011, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 15 Dec 2011 22:56:45 -0500
Reply-To:     "kenneth wilford (Van-Again)" <kenwilfy@COMCAST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         "kenneth wilford (Van-Again)" <kenwilfy@COMCAST.NET>
Subject:      Re: 1.9L WBX Compression Test Question
Comments: To: Skip <skiplaubach@comcast.net>
In-Reply-To:  <2101421890.1159258.1324001335385.JavaMail.root@sz0094a.emeryville.ca.mail.comcast.net>
Content-Type: text/plain; charset=ISO-8859-1

On the cylinders with low compression, try readjusting the valves to just touching (zero lash) and retest compression. Sometimes that can really help.

Ken Wilford John 3:16 www.vanagain.com On Dec 15, 2011 9:08 PM, "Skip" <skiplaubach@comcast.net> wrote:

> '84 Westy, 1.9L WBX, Manual Trans > > Runnability issues continue. A couple of weeks ago (after replacing the > ECU and Temp II sensor, and smooth running for 100 miles and good warm > starting) the van was sputtering/losing power, then stopped. Wouldn't > restart. Had my second tow with AAA Premium, this time to my mechanic. > When we off-loaded the van at the mechanic's, the van restarted...I left > it with the mechanic to check over. He identified the usual (hoses that > need to be replaced, etc.), but couldn't figure out the runnability issue. > He has a very good reputation, so I don't doubt his expertise. So he did > a compression test on the cylinders. Results were interesting and I would > welcome recommendations for further study or repair: the two rear > cylinders measured 155 on each side, the two front cylinders measured 65. > So, the engine sounds pretty OK and runs OK...sometimes, and I would guess > that the reason is that the compression is the same on opposite cylinders. > So has anyone experienced this phenomenon or can recommend "steps" toward > a correction? I stopped my an automotive machine shop today and was quoted > about $1500 (labor) plus parts (which include cylinders). BTW, no head > gasket leaks. Thank you. > > Skip Laubach > Elgin, IL >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.