thank you ... was wondering .. on the non-heated single wire 02 ..make sure it's warmed and running well, like at 2,000 rpm like you did. I have retrofitted the 2.1 waterboxer 3 wire heated 02 sensor to a 1.9 ...easy to do. It's totally low tech .. they just get "12 volts ignition" in the black junction box for the heater portion. Easy retrofit. I haven't found that very necessary actually .. perhaps for a 1.9 that spends time in traffic a lot say .. but otherwise a single wire one is OK. Lot cheaper too ...I've gotten a non-bosch one before for under 20 bucks. Scott www.turbovans.com ----- Original Message ----- From: "B Feddish" <uprightbassghost@HOTMAIL.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Monday, January 02, 2012 11:36 AM Subject: 02 sensor, part II
Sorry, forgot to mention, it’s a 1983 1.9 4SP. Thanks Bryan |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.